3-D panel construction, scaffolding is very necessary to build with this system, it is required on the exterior walls and interior walls and ceilings, most contractors or builders over look the need for proper scaffolding.

3-D panel construction. Note: the floor to wall connections, the concrete beams which where created at floors and walls, the 3-D panels were set n place one floor at a time.

3-D panel building system, a close view of rebar placed over the 3-D panel nine gauge welded wire mesh, the nine gauge galvanize wire are welded to each side of the panels two inch by two inch wire mesh, the Portland cement or shotcrete when placed strengthen this welded and we have a structural load bearing wall system.

3-D panel construction, screw jacks and shoring to support the 3-D panel roof and floors. I sometimes install this after the 3-D panels have been set in place. The 3-D panels will take the span, the shoring is necessary only to hold the panel’s level and straight while applying Portland cement or shotcrete.